Gypsum Channel Machine

Gypsum Channel Making Machine has always excelled with its design form single machine customer can Form 4 profiles differently in 1 Roll Forming Machine. We are using a very advancing technology in that our specialty of one machine we are providing a machine in first time in India from that machine u can take out Four profiles at one Roll Forming Machine and that is our specialty.

ROLL FORMING MACHINE COMPLETE WITH.

  • De-coiler 1 ton cap.
  • Entry Gate with

· Roll Forming Line with 8 stations, 1 Gear Boxes & 5 H.P. electrical.

· Control Panel semi auto

  • Cutting Unit

TECHNICAL SPECIFICATIONS :- ( Plate body) (5 Profiles)

(Gypsum Section, Ceiling, perimeter, Inter, Angle, Retaining)

Maximum sheet width that can be formed : 650 mm

Maximum sheet thickness in G I Strips that can be formed : 0.8 mm

Horizontal distance between shafts : 190 mm

Number of forming stations : 8 nos.

Vertical station - : 4 nos.

Total HP for Line : 5 (ABB)

Speed of the machine : 5 mt/minute

Size of machine : 2000 x 1200 x 1100 mm

MANDREL UNCOILER

Coil weight : 1 MT Max

Coil width : 800 MM

Coil bore : 450 MM min, 510 MM max dia.

Mandrel movement : Manually adjusted

Back Tension : Manually adjusted

Description of the Roll Forming Machine. (5 Profiles )

Entry Gate
Entry gate will be provided for movement of sheet to roll former.

Main Base
The main base is MS fabricated structure and adequately ribbed to minimize the distortion. It is accurately machined on top and bottom surfaces the threaded holes are made on the bed for positioning the stands.

Mill stands (Station)

The stands are mounted on the bed of the machine the line alignment can be easily done due to guide ways arranged on the bed of the machine. Each forming head consists of a fixed housing and sliding type out board housing. The mill stands will be arranged to locate shafts mounted on taper bearings. For the top shafts the bearings are housed in the cartridge type bearing blocks. The bottom shaft bearings are located in the bored machined in the housings. The bottom arbors are fixed in position whereas the top arbors along with cartridge blocks could be raised or lowered in vertical guides machined in housings.

Roll shafts

The roll shafts dia. 55 mm will be manufactured from quality steel and will be keyed to locate tooling.

Drive

The drive to the roll former will be by means of a gear box system. The main drive will be provided by means of 5 HP motor

Tooling

One set of Tooling with EN31 grade will be from imported material suitable for your machine as standard supply. The same is involved in operations like rough machining, keyway, rough profiling, profile machining and inspection with final template for above.

Cutting Unit

Hydro press (with dais 6 Pieces. )

GEAR BOX – ELECON

Motor – ABB

Bearing –SKF